Chapter 3 Creating and Editing Screens
GETLASTERROR (Get the Last Error Value)
Equation
Var1 = GETLASTERROR
Explanation
This command is used to get last error value. If there is no error, the result of
GETLASTERROR will be 0. Even if each Macro is executed simultaneously, the error
messages will not affect the macro. For more details on error code information, refer
to section 3.14.4 Macro Error Messages on page 3-374.
Remark
Var1 can be internal memory only.
Example
Get the last error value and save into $0.
3-370 Revision May, 2010
To Next Page
Loading...