Delta Electronics NH Plus Series User Manual

4
Η
Installation and Wiring
4-2
3. The carton and the original packaging must remain sealed to prevent any possible
damage from mouse or similar creatures.
ʳ
ʳ
4-4 Installation Environment and Position
ʳ
4-4-1 Handling Safety
1. The NH Plus series UPS is equipped with casters so that you can roll the UPS in a short
distance to the desired location. During unpacking process, be sure to make full use of
manpower and a suitable machine (such as stacker) with sufficient capacity to carefully
move the UPS.
2. Casters are only suitable for moving on even surface. Avoid moving the UPS on bumpy
route, because this may cause damage of UPS or tip-over accident.
3. Push the UPS from either front or rear side otherwise could cause tip-over accident.
4. When the UPS needs a long-distance movement, make use of a suitable machine but
not casters of the UPS.
4-4-2 UPS Position
1. Position the UPS or external battery pack by suitable machine.
2. Refer to Table 4-1 and 4-2. Ensure that the UPS is positioned at a suitable floor which
can sustain for the weight.
3. After positioning the UPS, ensure to push C (Stop) to “ON” until strictly fastened and
adjust leveler to the floor.
Connect and power the loading only when the battery is fully charged. The
purpose is to make sure that the UPS can provide the backup power to loads when
a blackout occurs.
Please pay extremely close attention while unbolting the UPS from the shipping
pallet. Prevent any accident resulting from unexpected move.
A: Leveler
B: Caster
C: Sto
p
A
C
B

Delta Electronics NH Plus Series Specifications

General

Brand	Delta Electronics
Model	NH Plus Series
Category	UPS
Language	English