ASDA-B2-F Appendix C Basic Inspection and Maintenance
September, 2015 C-3
C
Maintenance
Please use and store the product in a proper site.
Periodically clean the surface of the servo drive and servo motor so as to avoid dust and
dirt.
Do not disassemble any mechanical part during maintenance.
Periodically clean the ventilation ports of the servo drive and do not use the product in a
high-temperature site for a long time so as to avoid malfunction.
The Lifetime of Machinery Parts
DC Bus Capacitor
DC bus capacitor will be deteriorated by the affection of ripple current. Its lifetime is
determined by the surrounding temperature and operating conditions. If it is operating in an
air-conditioned site, its lifetime can be up to 10 years.
Relay
The contact will be worn due to power-on or power-off which leads to poor contact. The
lifetime of relay is influenced by the power supply capacity; thus, the accumulative time of
turning on or off the power is about 100,000 times.
Cooling Fan
In continuous operation, the lifetime of the cooling fan is 2 to 3 years and it has to be
replaced then. However, if there is any unusual noise or vibration during inspection,
replacing a new one is a must.
To Next Page
Loading...
Need help?
General
