ASDA-M Chapter 8 Parameters
Revision December, 2014 8-77
P1-79 OVLPP
The setting of the percentage of the
overlap PR path
Address: 019EH
019FH
Parameter
Attribute：
Parameter for three axes
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
10
Control
Mode：
PR
Unit：
% (percentage)
Range：
1 ~ 30
Data Size：
32bit
Format：
DEC
Settings：
This parameter is for setting the percentage
of deceleration area of previous path in the
whole path during the PR path overlap.
To Next Page
Loading...
