Delta ASDA-M Series

ASDA-M Chapter 8 Parameters
Revision December, 2014 8-193
Data Size：
32bit
Format：
DEC
Settings：
Before issuing the macro command, the relevant parameters # 4
must be set in advance.
The function of the parameter is determined by the macro
command. Not every macro command has its relevant
parameters.
P5-94 CSDS
Motion Control Macro Command:
Command Parameter # 3
Address: 05BCH
05BDH
Parameter
Attribute：
Parameter for three axes
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
0
Control
Mode：
ALL
Unit：
-
Range：
-2147483648 ~ +2147483647
Data Size：
32bit
Format：
DEC
Settings：
Before issuing the macro command, the relevant parameters # 3
must be set in advance.
The function of the parameter is determined by the macro
command. Not every macro command has its relevant
parameters.
P5-95 CSDS
Motion Control Macro Command:
Command Parameter # 2
Address: 05BEH
05BFH
Parameter
Interface：
Parameter for three axes
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
0
Control
Mode：
ALL
Unit：
-
Range：
-2147483648 ~ +2147483647