ASDA Series Application Note Introduction of PR Operation
March, 2015 1-47
3. PR#10:
Figure 1.64 Settings of PR#10
a. Select Path PR#10.
b. Select Type [8] Write the specified parameter to the specified path in Type
Settings.
c. Enable interrupt function; select When this PR is executing, it interrupts the
previous one (1: YES).
d. As this PR is presented in an arrow-shaped frame, please select Auto move to
the next PR when completed (1: YES).
e. No delay time; Set 0 here.
f. Select 0: Parameter and P5-55 as the target.
g. Select 0: Constant and enter 10 at section Data.
PR
#10
(I)
Write
DLY =0
P5-55= 10
To Next Page
Loading...
