Delta ME300 Series - Page 107

Chapter 7 Optional AccessoriesME300
7-59
1. Parameter Setup
Press to select.
Press to select the
parameter group.
Once you select a
parameter group, press
to go into that
group.
For example: Set up source for the master frequency command.
In the Group 00 Drive Parameters,
use Up/Down keys to select parameter 20:
Auto
Frequency Command.
Press ENTER to go to
this parameter’s setting menu.
Use the Up/Down keys to choose a setting.
For example: choose 2 Analogue Input, and then
press
ENTER.
After you press ENTER, END is displayed which
means that the parameter setting is done
.
NOTE: When parameter lock/password protection
function
is enabled, “Pr. lock” displays on the upper
right corner of the keypad. In this case, it means that
the parameter cannot be written or is protected by the
password.
2. Quick Start (ME300 models do not support this function)
3. Application Selection List
This function enables you to select application and its parameter settings.
For example:
In the menu content, select 3: Application Selection List
Press ENTER to go into the Application Selection List.
Select Application
Press ENTER to enter the application selection screen, and the selected
application industry is “Fan”.
Press ENTER to enter the Fan application screen.
Press the Up/ Down keys to select the parameter to set.
3