Delta ME300 Series

Chapter 7 Optional AccessoriesME300
7-60
Choose 0: Normal duty or 1: Heavy duty according to your needs, and then
press ENTER.
4. Changed List
This function records the parameters you have changed.
For example:
Set Pr.13-00 Application Selection = 3: Fan.
Enter the changed list screen. List PrNum = 026 means that there are 26
parameters that have been changed.
Press ENTER to enter the changed list screen.
Use the Up/ Down keys to select the parameters to check or to change.
Press ENTER to enter the parameter.
5. Copy Parameter
Press ENTER to go to
001–004: content storage.
Four groups of parameters are available to copy.
The steps are shown in the example below.
Example: parameter saved in the motor drive.
1. Go to
“Copy Parameter”
2. Select the parameter group to copy and press
ENTER.
1. Select 1: keypad
 VFD.
2.
Press ENTER to go to the “keypad  VFD” screen.
Begin copying parameters until it is done.
After copying is done, the keypad automatically returns
to this screen.
Example: parameter
saved in the keypad.