Delta ME300 Series - Page 128

Chapter 7 Optional AccessoriesME300
7-80
File Copy Setting Fault Description
These faults occur when KPC-CC01 cannot perform the command after clicking the ENTER key in the
copy function.
LCD Display *
Fault Name
Description
Corrective Actions
Read only
(ERR1)
Parameter and file
are read-only
The property of the parameter / file is read-
only and cannot be written to.
1. Verify the specification in the user manual.
If this solution does not work, contact your
local authorized dealer for assistance.
Write in error
(ERR2)
Fail to write
parameter and file
An error occurred while writing to a parameter
/ file.
1. Check for any problem on the Flash IC.
2.
Shut down the system, wait for ten minutes,
and then restart the system.
If none of the above solutions work, contact
your local authorized dealer for assistance.
Drive operating
(ERR3)
AC drive is in
operating status
A setting cannot be changed while motor drive
is in operation.
1. Verify that the drive is not in operation.
If this solution does not work, contact your
local authorized dealer for assistance.
Parameter locked
(ERR4)
AC drive parameter
is locked
A setting cannot be changed because a
parameter is locked.
1. Check if the parameter is locked or not. If it
is locked, unlock it and try to set the
parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
Parameter
changing
(ERR5)
AC drive parameter
changing
A setting cannot be changed because a
parameter is being modified.
1. Check if the parameter is being modified. If
it is not being modified, try to change that
parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
Fault code
(ERR6)
Fault code
A setting cannot be changed because an error
has occurred in the motor drive.
1. Check if an error occurred in the motor
drive. If there is no error, try to change the
setting again.
If this solution does not work, contact your
local authorized dealer for assistance.
Warning code
(ERR7)
Warning code
A setting cannot be changed because of a
warning message given to the motor drive.
1. Check if there is a warning message given
to the motor drive.
If this solution does not work, contact your
local authorized dealer for assistance.