Delta ME300 Series - Page 291

Chapter 12 Description of Parameter Settings
ME300
12.1-06-14
06-31
Frequency Command for Malfunction
Default: Read only
Settings 0.00–599.00 Hz
 When a malfunction occurs, check the current Frequency command. If it happens again, it
overwrites the previous record.
06-32
Output Frequency at Malfunction
Default: Read only
Settings
0.00–599.00 Hz
 When a malfunction occurs, check the current output frequency. If it happens again, it overwrites
the previous record.
06-33
Output Voltage at Malfunction
3 Default: Read only
Settings 0.0–6553.5 V
 When a malfunction occurs, check the current output voltage. If it happens again, it overwrites the
previous record.
06-34
DC bus Voltage at Malfunction
Default: Read only
Settings
0.0–6553.5 V
 When a malfunction occurs, check the current DC voltage. If it happens again, it overwrites the
previous record.
06-35
Output Current at Malfunction
Default: Read only
Settings 0.00–655.35 Amp
 When a malfunction occurs, check the current output current. If it happens again, it overwrites the
previous record.
06-36
IGBT Temperature at Malfunction
Default: Read only
Settings -3276.7–3276.7
o
C
 When a malfunction occurs, check the current IGBT temperature. If it happens again, it
overwrites the previous record.
06-38
Motor Speed in rpm at Malfunction
Default: Read only
Settings -32767–32767 rpm
 When a malfunction occurs, check the current motor speed in rpm. If it happens again, it
overwrites the previous record.
06-39
Torque Command at Malfunction
Default:
Read only
Settings -32767–32767%