Denon AVR-1311 - Surround Mode Selection

17
ENGLISH
Advanced versionSimple version InformationBasic version
Playback (Basic operation)
n Playing a Blu-ray Disc player/DVD player
(vpage17)
n Playing a portable player (vpage17)
n Playing an iPod
®
(vpage18)
n Tuning in radio stations (vpage20)
Selecting a listening mode (Surround mode)
(vpage23)
n Selecting the input source (vpage17)
n Adjusting the master volume (vpage17)
n Turning off the sound temporarily (vpage17)
Playback (Advanced operation) (vpage29)
Important information
Before starting playback, make the connections between the different
components and the settings on the receiver.
NOTE
Also refer to the operating instructions of the connected components
when playing them.
Selecting the input source
Press the input source select button
(DVD, BD, TUNER, DOCK, SAT/CBL,
GAME, V.AUX
z
, TV) to be played
back.
The desired input source can be selected
directly.
z For operation with the main unit,
use V.AUX/PORTABLE.
Adjusting the master volume
Use VOL df to adjust the volume.
n When the “Volume Display” setting
(vpage35) is “Relative”
GAdjustable rangeH
– – –
–80.5dB – 18.0dB
n When the “Volume Display” setting (vpage35) is
“Absolute”
GAdjustable rangeH
0.0 – 99.0
• The variable range differs according to the input signal and channel
level setting.
You can also operate via the main unit.
In this case, perform the following
operations.
Turn MASTER VOLUME to adjust the
volume.
Turning off the sound temporarily
Press MUTE.
• The sound is reduced to the level set at “Mute Level” (vpage35).
• To cancel, press MUTE again. Muting can also be canceled by
adjusting the master volume.
Playing a Blu-ray Disc player/DVD
player
The following describes the procedure for playing Blu-ray Disc player/
DVD player.
1
Prepare for playback.
q Turn on the power of the TV,
subwoofer and player.
w Change the TV input to the input of
this unit.
e Load the disc in the player.
2
Press POWER ON to turn on
power to the unit.
3
Press BD or DVD to switch an
input source for a player used for
playback.
4
Play the component connected to this unit.
Make the necessary settings on the player (language setting,
subtitles setting, etc.) beforehand.
Playing a portable player
The following describes the procedure for playing portable player.
1
Connect the portable player to
this unit (vpage 15 “Connecting
a portable player”).
2
Press POWER ON to turn on
power to the unit.
3
Press V.AUX to switch the input
source to “V.AUX”.
4
Play the component connected to this unit.
1.AVR1311E2ENG3rd100617.inddSec:171.AVR1311E2ENG3rd100617.inddSec:17 2010/06/1718:24:142010/06/1718:24:14