EasyManuals Logo

Denon AVR-1507 Operating Instructions

Denon AVR-1507
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
Basic Operation Basic Operation
29
ENGLISH
ENGLISH
Press ENTER or SURROUND PARAMETER.
Press
GG
to select “OFF”.
Press
DD HH
to select “Bass” or “Treble”, then press
FF
GG
to set the level.
Can be adjusted within the range of –10 dB to +10 dB.
3
4
5
Set “Tone Defeat” to “ON” at step 3 in “Adjusting the
tone”.
Adjusting the speaker volume
Press [CH SELECT].
Press [CH SELECT] to select the speaker.
The settable speaker switches each time this button is pressed.
Press [
FF GG
] to adjust the volume.
The SW channel level can be turned off by decreasing it one step
from –12 dB.
OFF ´ –12 dB ´ +12 dB
1
2
3
Setting the tone control
Adjust the bass and treble to suit your tastes.
Press SURROUND PARAMETER.
Press
DD HH
to select “TONE DEF. ON”.
In the direct mode, “TONE” cannot be selected.
1
2
R O O M S I Z E M E D
1
T O N E D E F . O N
2
¢ Adjusting the tone
¢ When you do not want to adjust the tone
T O N E D E F . O F F
3
B A S S 0 d B
4
T R E B L E 0 d B
Listening to the radio
Check that the remote control unit is set to “AUDIO”.
Hold
<
PRESET
>
and press
<
POWER
>
.
The unit automatically begins searching for FM broadcast
stations.
When the first FM broadcast station is found, that station is
stored in the preset memory at channel A1.
Subsequent stations are automatically stored in order at preset
channels A1 to A8, B1 to B8, C1 to C8, D1 to D8, E1 to E8, F1 to
F8 and G1 to G8 for a maximum of 56 stations.
Channel A1 is tuned in after the auto preset memory operation is
completed.
Auto preset memory
This unit is equipped with a function for automatically searching for
FM broadcast stations and storing them in the preset memory.
If an FM station cannot be preset automatically due to poor
reception, use the “Manual tuning” operation to tune in the station,
then preset it using the manual “Preset memory” operation.
•To interrupt this function, press <ON/STANDBY>.
¢ Default settings
Auto tuner presets
A1 ~ A8
87.5 / 89.1 / 98.1 / 108.0 / 90.1 / 90.1 / 90.1 /
90.1 MHz
B1 ~ B8
522 / 603 / 999 / 1404 / 1611 kHz,
90.1 / 90.1 / 90.1 MHz
C1 ~ C8 90.1 MHz
D1 ~ D8 90.1 MHz
E1 ~ E8 90.1 MHz
F1 ~ F8 90.1 MHz
G1 ~ G8 90.1 MHz
Switch off the unit using <POWER>.
1
2

Table of Contents

Other manuals for Denon AVR-1507

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-1507 and is the answer not in the manual?

Denon AVR-1507 Specifications

General IconGeneral
Digital Inputs2 Optical, 1 Coaxial
Analog Inputs5
TunerAM/FM
Response Bandwidth10 Hz - 100 kHz
Signal-To-Noise Ratio98 dB
Total Harmonic Distortion0.08%
Input Sensitivity200 mV
Digital Sound Processor (DSP)Yes
HDMI SwitchingNo
Tuner Frequency RangeFM: 87.5 - 108 MHz, AM: 522 - 1611 kHz
Surround SoundDolby Digital, DTS, Dolby Pro Logic II
Input Impedance47 kOhm
Power Output75 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
DSP Presets5-channel stereo, Cinema EQ

Related product manuals