Denon AVR-1507 Operating Instructions

ENGLISH
37
ENGLISH
Advanced Setup – Part 1 Advanced Setup – Part 1
Current setting
Navigating through the System Setup items
Press SYSTEM SETUP, then press ENTER.
Press
FF GG
to select the item you want to set, then
press ENTER.
Press ENTER or
HH
to confirm the new settings.
Press SYSTEM SETUP to move the next category.
To cancel the system setup mode, press SYSTEM SETUP again.
To change the setting:
Press
DD HH
to select the item you want to change, then
press
FF GG
to change the setting.
1
2
3
4
5
The AVR-1507 is equipped with an alpha numeric front panel display
that can also be used to check and adjust settings. Some representative
front display examples are shown below.
About the front display
Use System Setup to customize a variety of settings to suit your
listening environment.
For the contents of a system menu and the initial setting of this unit
( page 36).
Category No.
1 7 T . T o n e Y e s <
Press
FF
to execute.
Currently selected line
1 C O A X 1 C D
Currently selected line
* S y s t e m S e t u p
1
2
S p e a k e r S e t u p
1 F r o n t L a r g e
3
5
Item No.
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
ENTER
D H F G
D H F G
ENTER
SYSTEM SETUP
SYSTEM SETUP
F GF G, ENTER
D HD H

Denon AVR-1507 Specifications

General

Digital Inputs	2 Optical, 1 Coaxial
Analog Inputs	5
Tuner	AM/FM
Response Bandwidth	10 Hz - 100 kHz
Signal-To-Noise Ratio	98 dB
Total Harmonic Distortion	0.08%
Input Sensitivity	200 mV
Digital Sound Processor (DSP)	Yes
HDMI Switching	No
Tuner Frequency Range	FM: 87.5 - 108 MHz, AM: 522 - 1611 kHz
Surround Sound	Dolby Digital, DTS, Dolby Pro Logic II
Input Impedance	47 kOhm
Power Output	75 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
DSP Presets	5-channel stereo, Cinema EQ