Denon AVR-1507 Operating Instructions

2
ENGLISH
ENGLISH
Speaker Setup
Setting the Speaker Configuration ···············································41
Setting the Subwoofer Mode Setup············································42
Setting the Distance·····································································42
Setting the Crossover Frequency ················································42
Setting the Test Tone ···································································43
Troubleshooting············································································
51
Additional Information···························································
49, 50
Specifications················································································
52
List of preset codes ············································End of this manual
Operating DENON audio components ·······································44
Setting the preset memory function··········································44
Operating a component stored in the preset memory····45 ~ 47
Setting the punch through function···········································48
Advanced Setup – Part 2
Operating the remote control unit
Accessories
Check that the following parts are attached in addition to the main
unit:
q Operating instructions ..............................................................1
w Service station list ....................................................................1
e Remote control unit (RC-1049).................................................1
r R6P/AA batteries ......................................................................2
t AM loop antenna ......................................................................1
y FM indoor antenna ...................................................................1
u Setup microphone (DM-S205) (Approx. 6 m)...........................1
rt
u
e
y
Getting Started
Before using
Pay attention to the following before using this unit:
• Moving the unit.
To prevent short-circuits or damaged wires in the connection cables,
always unplug the power supply cord and disconnect the connection
cables between all other audio components when moving the unit.
• Cautions on using mobile phones.
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
•Before turning the power operation button on.
Check once again that all connections are correct and that there are
not problems with the connection cables. Always set the power
operation button to the standby position before connecting and
disconnecting connection cables.
• Store these instructions in a safe place.
After reading, store this instructions along with the warranty card in
a safe place.
• Whenever the power operation button is in the STANDBY state,
the unit is still connected to AC line voltage.
Please be sure to turn off the power operation button or unplug
the cord when you leave home for, say, a vacation.
• Note that the illustrations in these instructions may differ from
the actual unit for explanation purposes.
System setup items and default values·····································36
Navigating through the System Setup items ···························37
About the front display································································37
Input Setup
Setting the Digital In Assignment ················································38
Setting the iPod Assignment ······················································38
Setting the Audio Delay ·······························································38
Setting the EXT. IN Subwoofer Level ·········································39
Setting the Auto Preset Memory·················································39
Option Setup
Setting the Volume Control··························································40
Setting the Auto Surround Mode·················································40
Advanced Setup – Part 1

Denon AVR-1507 Specifications

General

Digital Inputs	2 Optical, 1 Coaxial
Analog Inputs	5
Tuner	AM/FM
Response Bandwidth	10 Hz - 100 kHz
Signal-To-Noise Ratio	98 dB
Total Harmonic Distortion	0.08%
Input Sensitivity	200 mV
Digital Sound Processor (DSP)	Yes
HDMI Switching	No
Tuner Frequency Range	FM: 87.5 - 108 MHz, AM: 522 - 1611 kHz
Surround Sound	Dolby Digital, DTS, Dolby Pro Logic II
Input Impedance	47 kOhm
Power Output	75 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
DSP Presets	5-channel stereo, Cinema EQ