Basic Operation Basic Operation
30
ENGLISH
ENGLISH
Use <INPUT SELECTOR
>
to select “TUNER” or press
[TUNER].
Auto tuning
Manual tuning
Press [MODE] to set the auto tuning mode.
• The “AUTO” indicator lights.
Press TUNING.
• Automatic searching begins.
• If tuning does not stop at the desired station, use to the “Manual
tuning” operation.
Use
<
INPUT SELECTOR
>
to select “TUNER” or press
[TUNER].
Press [MODE] to set the manual tuning mode.
Check that the display’s “AUTO” indicator turns off.
Press BAND to select “AM” or “FM”.
Press BAND to select “AM” or “FM”.
Press TUNING.
The frequency changes continuously when the button is held in.
1
2
3
4
1
2
3
4
• When the manual tuning mode is set, FM stereo broadcasts are
received in monaural and the “STEREO” indicator turns off.
Use the “Auto tuning” or “Manual tuning” operation
to tune in the station to be preset in the memory.
Press [MEMORY].
Press CHANNEL to select the desired preset channel
(1 to 8).
Preset memory
Press SHIFT to select the desired memory block (A to
G).
Press [MEMORY] again.
• Store the station in the preset memory.
1
2
3
4
5
•To preset other channels, repeat steps 2 to 5.
A total of 56 broadcast stations can be preset — 8 stations (channels
1 to 8) in each of blocks A to G.
• The memory block can also be selected by pressing SHIFT.
Recalling preset stations
Press SHIFT to select the memory block.
Press CHANNEL to select the desired preset channel.
1
2
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
To Next Page
Loading...
Need help?
General
