Denon AVR-1507 Operating Instructions

ENGLISH
39
ENGLISH
Advanced Setup – Part 1 Advanced Setup – Part 1
Setting the EXT. IN Subwoofer Level
Press ENTER or
HH
to enter the setting and switch to
the Auto Preset Memory setting.
2
Sets the playback level of the analog signal that was input to the EXT.
IN subwoofer terminal.
+15 dB, +10 dB, +5 dB, 0 dB:
Sets the playback level of the analog signal that was input to the
EXT. IN subwoofer terminal.
Press
FF GG
to set.
1
7 E X T . I n S W + 1 0
1
8 P r e s e t < S t a r t
2
Setting the Auto Preset Memory
Up to 56 FM stations can be preset automatically ( page 29).
Press
FF
to start.
• “CH” blinks on the display and searching begins.
• “Completed” appears once searching is completed.
• If an FM station cannot be preset automatically due to poor
reception, use the “Manual tuning” operation ( page 30) to tune
in the station, then preset it using the manual “Preset memory”
operation ( page 30).
1
Press ENTER to enter the setting and switch to the
Option Setup.
2
S e a r c h
1
C O M P L E T E D
2

Denon AVR-1507 Specifications

General

Digital Inputs	2 Optical, 1 Coaxial
Analog Inputs	5
Tuner	AM/FM
Response Bandwidth	10 Hz - 100 kHz
Signal-To-Noise Ratio	98 dB
Total Harmonic Distortion	0.08%
Input Sensitivity	200 mV
Digital Sound Processor (DSP)	Yes
HDMI Switching	No
Tuner Frequency Range	FM: 87.5 - 108 MHz, AM: 522 - 1611 kHz
Surround Sound	Dolby Digital, DTS, Dolby Pro Logic II
Input Impedance	47 kOhm
Power Output	75 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
DSP Presets	5-channel stereo, Cinema EQ