20
ENGLISH
n Using the “Source Select” menu
q Press SOURCE SELECT.
Display the “Source Select” menu.
DVD
BD
TV
GAME
SAT/CBL
V.AUX
DOCK
TUNER
Source Select
[ENT]:Select
[ ]:Source
The currently selected input source
is highlighted.
w Use uio p to select the input source,
then press ENTER.
The input source is set and the source
selection menu is turned off.
• Input sources that are not going to be used can be set ahead of time.
Make this setting at “Source Delete” (vpage53).
• To turn off the source selection menu without selecting an input
source, press SOURCE SELECT again.
n Using the knob on the main unit
Turn SOURCE SELECT.
• Turning SOURCE SELECT switches
the input source, as shown below.
BD DVD TV SAT/CBL
GAMEV.AUXDOCKTUNER
Important information
Adjusting the master volume
Use VOL df to adjust the volume.
n When the “Volume Display” setting
(vpage53) is “Relative”
GAdjustable rangeH
– – –
–80.5dB – 18.0dB
n When the “Volume Display” setting (vpage53) is
“Absolute”
GAdjustable rangeH
0.0 – 99.0
• The variable range differs according to the input signal and channel
level setting.
You can also operate via the main unit.
In this case, perform the following
operations.
Turn MASTER VOLUME to adjust the
volume.
Turning off the sound temporarily
Press MUTE.
• The sound is reduced to the level set at “Mute Level” (vpage53).
• To cancel, press MUTE again. Muting can also be canceled by
adjusting the master volume.
Playing a Blu-ray Disc player/DVD
player
The following describes the procedure for playing Blu-ray Disc player/
DVD player.
1
Prepare for playback.
q Turn on the power of the TV,
subwoofer and player.
w Change the TV input to the input of
this unit.
e Load the disc in the player.
2
Press POWER ON to turn on
power to the unit.
3
Press BD or DVD to switch an
input source for a player used for
playback.
4
Play the component connected to this unit.
Make the necessary settings on the player (language setting,
subtitles setting, etc.) beforehand.
To Next Page
Loading...
