Denon AVR-1611 User Manual

67
ENGLISH
Basic version Advanced versionSimple version Information
Surround
n Types of input signals, and corresponding surround modes
This table shows the input signal that can be played in each surround mode. Check the audio signal of the input source then select the surround mode.
Symbols in the table
F This indicates the default surround mode.
D This indicates the surround mode that is fixed when “AFDM” (vpage44) is set to “ON”.
S This indicates the selectable surround mode.
Surround mode (vpage24)
NOTE
Input signal types and formats
ANALOG
PCM DTS-HD DTS DOLBY DOLBY DIGITAL
LINEAR PCM
(multi ch)
LINEAR PCM
(2ch)
DTS-HD
Master
Audio
DTS-HD
High
Resolution
Audio
DTS
EXPRESS
DTS ES
DSCRT
(With Flag)
DTS ES
MTRX
(With Flag)
DTS
(5.1ch)
DTS 96/24
DOLBY
TrueHD
DOLBY
DIGITAL Plus
DOLBY
DIGITAL EX
(With Flag)
DOLBY
DIGITAL EX
(With no
Flag)
DOLBY
DIGITAL
(5.1/5/4ch)
DOLBY
DIGITAL
(4/3ch)
DOLBY
DIGITAL
(2ch)
DTS SURROUND
DTS-HD MSTR
F
DTS-HD HI RES
F
DTS ES DSCRT6.1
z1z3 F D
DTS ES MTRX6.1
z1z3 F D
DTS SURROUND
S S F
DTS 96/24
F
DTS (–HD) + PLgx CINEMA z2z3 S S S S S S S
DTS (–HD) + PLgx MUSIC z1z3 S S S S S S S
DTS (–HD) + PLgz z4 S S S S S S S
DTS EXPRESS
F
DTS (–HD) + NEO:6
z1z3 S S S S S S
DTS NEO:6 CINEMA
S S S
DTS NEO:6 MUSIC
S S S
DOLBY SURROUND
DOLBY TrueHD
F
DOLBY DIGITAL+
F
DOLBY DIGITAL EX
z1z3 S S S S
DOLBY (D+) (HD) +EX
z1z3 S S
DOLBY DIGITAL
S F F F
DOLBY (D) (D+) (HD) +PLgx CINEMA z2z3 S S F D S S S
DOLBY (D) (D+) (HD) +PLgx MUSIC z1z3 S S S S S S
DOLBY (D) (D+) (HD) +PLgz z4 S S S S S S
DOLBY PRO LOGIC gx CINEMA z1z3 S S S
DOLBY PRO LOGIC gx MUSIC z1z3 S S S
DOLBY PRO LOGIC gx GAME z1z3 S S S
DOLBY PRO LOGIC gz z4 S S S
DOLBY PRO LOGIC g CINEMA S S S
DOLBY PRO LOGIC g MUSIC S S S
DOLBY PRO LOGIC g GAME S S S
DOLBY PRO LOGIC
S S S
z1 If “Speaker Config.” – “S.Back” (vpage49) is set to “None”, this surround mode cannot be selected.
z2 If “Speaker Config.” – “S.Back” (vpage49) is set to “1sp” or “None”, this surround mode cannot be selected.
z3 This item can be selected when “Amp Assign” (vpage49) is set to “Normal”.
z4 If “Speaker Config.” – “Front Height” (vpage49) is set to “None”, this surround mode cannot be selected.

Denon AVR-1611 Specifications

General

Impedance	6 Ω
Frequency range	10 - 100000 Hz
Audio output channels	5.1 channels
Audio A/D Converter (ADC)	24-bit/96kHz
Signal-to-Noise Ratio (SNR)	98 dB
Total Harmonic Distortion (THD)	0.7 %
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
Radio Data System (RDS)	Yes
Audio system	Dolby TrueHD, Dolby Digital Plus, Dolby Digital EX, Dolby Pro Logic II, Dolby Pro Logic IIx, Dolby Pro Logic IIz, DTS-HD, DTS 96/24
Output power	110 W
Dimensions (WxDxH)	434 x 381 x 171 mm
Power requirements	AC 230, 50 Hz
HDMI ports quantity	5
I/O ports	1 x Component 3 x Composite (Video) 5 x Analogue Audio (Tuner included) 1 x Composite Monitor 1 x Microphone Port 1 x Dock Control Port 1 x FM Tuner Antenna 1 x AM Tuner Antenna
Connectivity technology	Wired
Digital audio optical in	1
Product color	Black
Power consumption (standby)	0.1 W
Power consumption (typical)	360 W

Weight and Dimensions

Weight	9200 g