[41 Registering device names
Use the procedure described below to register
names, etc., for registered devices.
@ Press “SETUP” in the icon display section for at
least 3 seconds to display the setup screen.
Press the “Device Label” button on the “Setup
l/4” page to display the device selection screen.
@ Use the A and - buttons in the icon
display section to display the icon for the device
for which you want to register a device name,
etc., then press that icon.
@ Input the device name, etc.
” ” (under bar) is displayed at the left edge. The
place where this is displayed can be edited.
For rnstructions on inputting the device name,
etc., refer to section “Inputting button names”
on page 19.
Once the device name, etc., has been input,
press the “OK” button to register that device
name.
Screen @I
Screen is’I
Registered device names are drsplayed as shown below
Up to 16 characters can be input for device names.
3evice name
28
To Next Page
Loading...
Need help?
General
