3.5.4. Clearing the Protection History
There are two ways to clear the protection history.
(1) Start Protection History Display Mode. Press the button "
STATUS
" to display the protection history. Press and hold the
button "
DIMMER
" for 3 seconds.
FLD
P R T : D C
Press and hold the button "
DIMMER
" for 3 seconds.
FLD
P R T : C L E A R
The above is displayed and the protection history is cleared.
FLD
N O P R O T E C T
(2) Initialize this unit. ( "See "
Initializing This Unit
" 11 page )
b
Use the method in
3.5.3.(1)
if you do not want to erase your settings from this unit.
Warning Displays by POWER LED
If the power is turned off while a protection is detected, the POWER LED (red) ashes in the following ways as a warning
according to the protection status.
(1) ASO/DC protection: Flashes in 0.5-second cycles (0.25 seconds lit, 0.25 seconds unlit)
(2) THERMAL (A/B) protection: Flashes in 2-second cycles (1 second lit, 1 second unlit)
46
To Next Page
Loading...
