89
2D Code Handy Terminal
- Point - QR Code has a function where data is coded after being split into a maximum of 16
segments and the segmented codes are read. Codes segmented using this function are
called concatenated codes.
When reading concatenated codes, the beeper works differently than with normal reading.
The beeper sounds twice when the first code of the concatenated code is read, and the
system enters the concatenated code reading mode. When subsequent concatenated codes
are raed, the beeper sounds once. After the final code has been read, the beeper sounds
three times and reading is complete.
The reading data screen display will not be shown until after concatenated code reading is
complete.
If QR codes other than concatenated codes are read during concatenated code reading
those codes are displayed, the concatenated code reading mode is cancelled and the read
concatenated codes are discarded. This also happens if the trigger switch is released or the
interval between reading of concatenated codes is over 5 seconds.
The order for reading concatenated codes is arbitrary. The same concatenated codes will not
be read it again.
- Point - Option data is displayed at the end of the QR Code data when OPTION DATA is set to ON at
the set code reading conditions screen of the SET SYSTEM menu. (Refer to “4.5.5 [4]
Setting the code reading conditions”)
To Next Page
Loading...
