11
Leveling the Balance
Purpose:
– To compensate for unevenness at the place
of installation
Always level the balance again any time after
it has been moved to a different location.
Only the 2 front feet are adjusted to level the
balance.
§ Retract the two rear feet (only on models
with a rectangular weighing pan).
§ Turn the 2 front feet as shown in the dia-
gram until the air bubble is centered within
the circle of the level indicator.
> In most cases this will require several
adjustment steps.
§ On models with a rectangular weighing pan:
Lower the 2 rear feet until they touch the
surface on which the balance rests.
Anti-theft Locking Device
§ To secure the balance at the place of instal-
lation, fasten a chain or a lock to the lug
located on the rear panel of the balance.
To Next Page
Loading...
