36
Net-total Formulation
Display symbol: R
Purpose
With this application program you can
weigh in individual components either
by their individual weight or by the
total weight. You can print out both
the total weight and the individual
weights of the components.
Preparation
§ Select the Net-total application in
the menu:
see “Configuration.”
§ Set the following parameters:
Applic. Application program
Net-TotL. Net-total formulation
Comp.Prt. Printout of components
Off
o On
o = Factory setting
Features
– Weigh up to 99 components from
“0” to a defined total component
weight.
– Store component weights
(printout shows
Comp xx), with
– display zeroed automatically
after value is stored, and
– automatic printout
– Clear component memory follow-
ing cancellation of the weighing
sequence (by pressing ) and
printout of the total weight.
– Toggling between component
weight and total weight by press-
ing and holding (< 2 sec).
– Printout of the total of the individ-
ual component weights (T-Comp)
Printout: Net-total formulation
Comp 2+ 278.1 g : Second
component
T-Comp+ 2117.5 g : Sum of
components
To Next Page
Loading...
