Desoutter CVI3 Vision Configuration Manual

- 8 - 6159924940 - 07/2020
CVI3 Essential / CVI3 Function
1. From the start screen, press Escape to enter the screen Control mode.
2. Keep pressing Enter up to the screen Service.
Press Up or Down key up to the screen Language.
3. Press the Left or Right key. The name of the language is blinking.
Select the language.
4. Press Enter to validate.
CVI3 Vision and TWINCVI3
Tap this icon to go to the main menu.
Tap Configuration / Controller / User interface / Language.
Select your language by tapping the screen or the arrows.
Validate the selection.
Synchronizing date and time
This function is used to synchronize the date and time in controllers and software to ensure that the tightening results
are stored with the correct date and time.
Select the date and time format.
DD/MM/YY hh:mm:ss
YY/MM/DD hh:mm:ss
MM/DD/YY hh:mm:ss
Select the source which will synchronize the date and time in the controller.
For example: If Sync source is set to CVI CONFIG, the controller date and time will be updated during the data
transfer from the software to the controller.
• None
• CVI CONFIG
• CVINET WEB
• Fieldbus
• Ethernet protocol
• Server NTP: enter the server address.
• Toolsnet
For CVI3 Essential / CVI3 Function, go to Configuration > Service > Date and use the keys up and down to change
the current date. Do the same to change the time.
For CVI3 Vision and TWINCVI3, go to Configuration > Controller > User interface > Date and time, do the se-
lections and tap the icon Save to validate.
Setting the controller beep
When this function is enabled, a sound is emitted each time a button is pressed.
For CVI3 Essential / CVI3 Function, go to Configuration / Service / Beep and use the keys up and down to disable
or enable the beep.
For CVI3 Vision and TWINCVI3, go to Configuration / Controller / User interface / Display and tick or untick
Keypad beep enabled.
Setting the torque and speed units
Select the units according to your requirements.
The following torque units are available: Nm, ft lb, in lb, kg m, kg cm, oz in.
The following speed units are available: rpm or a percentage of the maximum tool speed.

Desoutter CVI3 Vision Specifications

General

Brand	Desoutter
Model	CVI3 Vision
Category	Controller
Language	English