To Next Page

To Previous Page

0065-0647-OM Rev E 7550 OWNER’S MANUAL

SCALE SETUP, CONT.

Settings Page 8

SETTINGS PAGE 8

DHCP: On

IP: 192.168.0.133

NM: 255.255.255.0

GW: 192.168.0.1

<<< Exit

DHCP:

Touching this key will open an entry screen to allow you to select the DHCP setting. This

setting selects whether the Wi-Fi wireless transmitter will use a dynamic IP address

assigned by a DHCP server or a static IP address. Consult with your network administrator

for the proper selection. Using the numeric keys, enter a new setting, and then press Save.

Allowable settings for DHCP are: 0 = Static IP (Off), 1 = DHCP (On)

NOTE: If the setting for DHCP: = Off, the settings for NM: (Netmask) and GW:

(Gateway Address) will be shown on the touchscreen.

NM: (Netmask)

Touching this key will open an entry screen to allow you to enter the Wi-Fi network Netmask

for the network the scale will be connected to. Using the numeric keys, enter a new setting,

and then press Save.

The format for the Netmask is: ### . ### . ### . # (e.g., 255.255.255.0).

IMPORTANT! The Netmask of the scale should match the Netmask of the other computers

on your network.

GW: (Gateway Address)

Touching this key will open an entry screen to allow you to enter the Wi-Fi network Gateway

Address for the network the scale will be connected to. Using the numeric keys, enter a new

setting, and then press Save.

The format for the Gateway Address is: #, #, #, # (e.g., 192.168.0.1).

Press <<< to return to the Settings Page 7.

Press Exit to exit Setup and return to the Weight screen.

The settings for NM:

and GW: will not be

shown if DHCP: = On.

Detecto 7550 User Manual

Other manuals for Detecto 7550