To Next Page

To Previous Page

0065-0647-OM Rev E 7550 OWNER’S MANUAL

WI-FI SETUP, CONT.

Enable and Configure Wi-Fi Networking, Cont.

10. Press >>> to advance to the Settings Page 8.

SETTINGS PAGE 8

DHCP: On

IP: 192.168.0.133

NM: 255.255.255.0

GW: 192.168.0.1

<<< Exit

11. Touch DHCP: to open an entry screen to allow you to select the DHCP setting. This setting

selects whether the Wi-Fi wireless transmitter will use a dynamic IP address assigned by a

DHCP server or a static IP address. Consult your network administrator for the proper

selection.

Using the numeric keys, enter a new setting, 0 = Static IP (Off) or 1 = DHCP (On), and

then press Save.

NOTE: If the setting for DHCP: = Off, the settings for NM: (Netmask) and

GW: (Gateway Address) will be shown on the touchscreen.

12. Touch NM: to open an entry screen to enter the Wi-Fi network Netmask for the network the

scale will be connected to, and then press Save.

The Netmask of the scale should match the Netmask of the other computers on your

network. The format for the Netmask is ### . ### . ### . # (e.g., 255.255.255.0).

13. Touch GW: to open an entry screen to enter the Wi-Fi network Gateway Address for the

network the scale will be connected to, and then press Save.

The format for the Gateway address is: # . # . # . # (e.g., 192.168.0.1).

14. Press Exit to exit Setup and return to the Weight screen.

15. Proceed to the Configure Wi-Fi Network Module section.

The settings for NM:

and GW: will not be

shown if DHCP = On

Detecto 7550 User Manual

Other manuals for Detecto 7550