How to fix streaks on Develop D 1650iD copies?
Streaks in your copies can be caused by a few things. First, the Original Glass might be dirty, so wipe it with a soft, dry cloth. Alternatively, the document pad could be dirty; clean it with a soft cloth dampened with a mild detergent. Finally, if you're copying a highly translucent original, like diazo photosensitive paper, try placing a blank sheet of paper over the document.
Why is my Develop Copier making light copies?
If your copies are coming out too light, it could be due to a couple of reasons. The copy density might be set too light; use the Auto/Photo key to select a darker copy density. It's also possible that the copy paper is damp, in which case you should replace the paper.
What to do if Develop D 1650iD Copier copies are blurry?
Blurry copies can occur if the copy paper is damp, so try replacing it. Also, ensure the document is pressed closely against the Original Glass when copying.
Why Develop Copier doesn't start when I press the start button?
If the [Start] key is pressed but no copies are made, and the “Error” indicator on the Control Panel is lit, an error has occurred, follow the instructions in any messages that appear on the display. If the machine was just turned on, it is still warming up. The machine takes about 30 seconds to warm up after it is turned on.
Why is the display blank on my Develop D 1650iD Copier?
If nothing appears on the display, the machine might be in Energy Saver mode (preheat mode). Press any key to cancel Energy Save mode. Alternatively, the “AUTO SHUT OFF” function may have been activated. Set the Power Switch to “O”.
Why is the edge of the copy dirty on my Develop D 1650iD Copier?
If the edge of the copy is dirty, the document pad is likely dirty. Clean the document pad with a soft cloth dampened with a mild detergent.
Why is the back side of a double-sided document showing up on my Develop D 1650iD copies?
If you're copying a thin double-sided document, the information on the back side may be reproduced in the copy. Use the Auto lighter density for the background to resolve this.
General| Printing technology | Laser |
|---|---|
| Copying | Yes |
| Maximum Copy Resolution | 600 x 600 DPI |
| Faxing | No |
| Connectivity | USB |
To Next Page