Need help?Do you have a question about the Deviation Devo 6 and is the answer not in the manual?
General| Brand | Deviation |
|---|---|
| Model | Devo 6 |
| Category | Remote Control |
| Language | English |
Template for switches to manipulate inputs, allowing different curve/function for each position.
Defines how mixers are applied: Replace, Add, Multiply, Max, Min.
Configuration options include Mixers count, Page, Switch, Mux, Src, Curve, Scale, Offset.
General form of a mixer: M(x) = if(Switch) { Src * Curve * Scale + Offset } else {0} + Trim.
Explains logic for Replace, Multiply, Add, Max, and Min mux types.
Lists supported curves: 1-to-1, Fixed, Min/Max, Zero/Max, >0, <0, ABSVAL, EXPO, Deadband, Multi-point.
How to access and use the Curve Editor for EXPO, Deadband, and Multi-point curves.
Configure servo rotation direction and failsafe values for each channel.
Set minimum/maximum limits and scale factors for servo throw.
Adjust servo zero point (sub-trim) and maximum servo speed.
General information on protocol customization, limits, and installation guide link.
Controls Spektrum/JR models, supports up to 14 channels, no auto-binding.
Controls Spektrum/JR models, supports up to 12 channels, requires manual binding.
Selects helicopter type and configures swashplate settings (SwashType, ELE/AIL/COL Inv, ELE/AIL/COL Mix).
Assigns channels 1, 2, and 5 to Cyclic1, Cyclic2, and Cyclic3 templates.
Shows new virtual channels created after setting Cyclic templates.
Dual-rate settings for Aileron, Elevator, and Rudder with Expo and linked rates.
Configuration details for low-rates with dual-rate switches for Elevator and Aileron.
Setup to enable 3D with FMODE1 and FMODE2 for pitch, using 5-point curves.
Uses complex mixer for throttle-hold, allowing zero throttle but continuous Collective function.
Details the configuration of 4 pages for throttle setup using complex mixers and switches.
To Next Page