Standard GUI
The Standard GUI is an alternative interface from the Advanced GUI’. Which interface
is used is chosen by the ‘Mixer GUI’ on the Model Page. The Standard GUI is only
available for Helicopter-type models at this time. The pages of the Standard GUI are as
follows:
Model configuration (See page 22)
Servo reverse (See page 31)
Servo sub-trim (See page 32)
Servo travel-adjust (See page 32)
Swash Setup (See page 33)
Dual-rates setup (See page 33)
Throttle curve setup (See page 34)
Pitch curve setup (See page 34)
Gyro-sense configuration (See page 35)
Trim configuration (See page 22)
Page | 30
To Next Page
Loading...