Swash Configuration (Standard GUI)
The Swash configuration page configures the swash type. These settings are equivalent
to the settings on the 'Helicopter’ configuration sub-page of the Model page (see page
22).
The available values are:
• 1Servo: Used For FBL. All mixing occurs in Rx
• 3Servo 120: 120-degree swash
• 3Servo 120x: 120 degrees swash (alternate config)
• 3Servo 140: 140 degree swash
• 3Servo 90: 90 degrees swash
Dual-Rate/Expo setting (Standard GUI)
The dual-rate and expo page allows configuration of curves for the Aileron, Rudder, and
Elevator channels. Up-to 3 rates can be configured for each channel, and either a scaled-
linear or exponential curve can be selected for each. The number of settings depends on
the switch assigned to the dual-rates function on the Switch Assignment page (see page
35)
Page | 33
To Next Page
Loading...