Dickey-John PM300E - Hi;Low Population Warning; Fan Speed Low;Hi Limit Warning

OPERATOR’S MANUAL
PM300E and PM332E Planter Monitors
11001-1423-200710
ALARMS / 37
HI/LOW POPULATION WARNING
The Hi and Low population alarm triggers when seed flow drops below the
population alarm limit set on the Limits Setup screen. The alarm display will
beep and flash on the screen briefly indicating row units are over or under
the desired population. The Main Operate screen will display the row unit
over or under population symbol until corrected, All Rows Failure occurs, or
sensor mechanical problems are fixed.
Figure 27
Population Limit Warning Display
FAN SPEED LO/HI LIMIT WARNING
Fan speed alarms are triggered with a solid-on alarm when any fan speed
exceeds or falls below the value entered for Fan Speed Lo/Hi Limits in the
Setup mode. Alarm can be silenced by pressing Alarm Cancel key, but will
re-activate if problem is not resolved.
Figure 28
Fan Speed Limit Warning Display (Optional)
2 4 6 8
2 4 6 8
LOW FAN SPEED
HIGH FAN SPEED