Dickey-John PM300E - Self-Test Failure; High Ground Speed Exceeded (Optional)

OPERATOR’S MANUAL
PM300E and PM332E Planter Monitors
11001-1423-200710
40 / ALARMS
SELF-TEST FAILURE
The Self Test Failure alarm activates at every power cycle comparing
configured number of rows to number of rows detected. Any sensor not
found during self-test or inaccurate configuration will sound alarm and
display on the Main Operate screen. The alarm can be acknowledged by
pressing the Alarm Cancel key, but will re-activate until problem is
resolved.
Figure 33
Self Test Failure
HI GROUND SPEED EXCEEDED (OPTIONAL)
The Hi Ground Speed Exceeded alarm is triggered anytime the speed has
exceeded the kmh/mph input in the Ground Speed Setup screen. Alarm can
be silenced by pressing the Alarm Cancel key.
Figure 34
Maximum Speed Exceeded Warning Display (optional)
2 4 5 6
SELF TEST FAILURE
7 8 9
10
11
12
HI GROUND SPEED