Get started Verify product components
AnywhereUSB® Plus User Guide
13
Item Name Description
2 USB LEDs and ports
The USB port supports 1.1, 2.0, and 3.1 USB devices.
The LED illuminates as follows, based on the speed of the USB
device:
n 1.1 (Full speed): Yellow
n 2.0 (High speed): Green
n 3.1 (Super speed): Blue
3 Reset button
Use this button to reset the AnywhereUSB® Plus Hub configuration
to factory defaults. See Use the Reset button to restore factory
defaults.
4 (Power) LED
The LEDis solid blue when the device is powered on.
This LED is also used for the Find Me feature. When this feature is
activated, the LED blinks blue and then orange. You can configure
the Find Me feature in the web UI or by using the findme CLI
command.
5 Power connector
Connect the power supply: 5 Volt DC center positive.
The Hub draws 5 Amp maximum when both USB ports are drawing
1.8 Amps each.
To Next Page
Loading...
Need help?
General