Configure the AnywhereUSB Manager from the command line group name
AnywhereUSB® Plus User Guide
98
group name
Purpose
Change or assign the local name of the group.
Syntax
>awusbmanager group name,<
address
,<
new name
>
The <group name> is the group's address.
The <new name> is the new local name for the group.
Examples
Run the list command to determine the group's address.
AnywhereUSB Manager, below are the available devices:
AW02-000001 "Hub 1" (AW02-000001.local.:18574)
Group 2 (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
Run the group name command.
>awusbmanager group name,AW02-000001.2,New Group
Run the list command again to verify the name change.
AnywhereUSB Manager, below are the available devices:
AW02-000001 "Hub 1" (AW02-000001.local.:18574)
Group 2 "New Group" (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
To Next Page
Loading...
