To Next Page

To Previous Page

Configure the AnywhereUSB Manager from the command line disconnect device

AnywhereUSB® Plus User Guide

disconnect device

Purpose

Disconnect from a USB device to which you no longer need access. You will remain connected to the

group that the device is in. Other users cannot connect the USBdevice, since you still own the group

that the USBdevice is in.

Note If you have auto connect enabled for the group, you can disconnect from a USB device in the

group, but note that for a stand-alone, the device will be reconnected the next time you stop and then

start the AnywhereUSB Manager. If you are running the AnywhereUSB Manager as a service, the

device remains disconnected until you reboot the PC or restart the service.

Syntax

>awusbmanager disconnect device,<

address

The <address> is the address of the device from which you want to disconnect.

Examples

Run the list command to view the address for device from which you want to disconnect.

AnywhereUSB Manager, below are the available devices:

AW02-000001 (AW02-000001.local.:18574)

Group 2 (AW02-000001.2) (In-use by you)

Group 1 (AW02-000001.1) (In-use by you)

U3 Cruzer Micro (AW02-000001.1101) (In-use by you)

* means Autoconnect enabled, + means Autoconnect inherited

Auto-Find: enabled

Autoconnect All: disabled

AnywhereUSB Manager not running as a service

Run the disconnect device command.

>awusbmanager disconnect device,AW02-000001.1101

Run the list command again to verify that the device is disconnected.