Digi AnywhereUSB Plus Series User Manual

Configure the AnywhereUSB Plus Hub from the CLI reboot
AnywhereUSB® Plus User Guide
136
reboot
Purpose
Reboots the Hub.
Note You can also reboot the Hub from the web UI. See Reboot the Hub.
Syntax
reboot
Wait approximately 15 seconds for the reboot to complete. When the reboot is complete, all the LEDs
turn on and then turn off, leaving the power LEDs on. For the AnywhereUSB 24 Plus model, one or both
of the power LEDs will be on.

Digi AnywhereUSB Plus Series Specifications

General

Network Interface	10/100/1000 Mbps Ethernet
USB Standard	USB 3.1 Gen 1
Security	SSL/TLS, SSH
Management	Web UI, CLI, SNMP
Power Supply	12V DC
Operating Temperature	0°C to 50°C
USB Ports	4 or 8