Regulatory information
The ConnectCore for i.MX51 product complies with the following standards.
Federal Communication (FCC) regulatory information (USA only)
Radio Frequency Interface (RFI) (FCC 15.105)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to correct the interference by one or more of the following measures:
n Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and the receiver.
n Connect the equipment into an outlet that is on a circuit different from the receiver.
n Consult the dealer or an experienced radio/TV technician for help.
Labeling Requirements (FCC 15.19)
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
If the FCC ID is not visible when installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module FCC ID.
RF exposure
RF Exposure considerations require that a 20cm separation distance between users and the installed
antenna location shall be maintained at all times when the module is energized. OEM installers must
consider suitable module and antenna installation locations in order to assure this in 20cm separation,
and end users be also be advised to the requirement.
ConnectCore for i.MX51 Hardware Reference Manual
142
To Next Page
Loading...
Need help?
General
