To Next Page

To Previous Page

About the development board LCD interfaces

ConnectCore for i.MX51 Hardware Reference Manual

n P1: corresponds to i.MX51 display interface 1

n P2: corresponds to i.MX51 display interface 2

LCD 1 connector, P1

This connector provides access to the following capabilities:

n 18-bit (RGB x 8bit) LCD

n SPI bus for a touch screen controller

n Touch screen (on-module, shared with LCD2)

n Interrupt input for touch screen

n I

C bus

n 2 x GPIO

n +3.3VDC supply and a 9-30VDC supply

P1 pinout

The table below shows the pinout of the LCD1 connector, P1:

Pin Function Pin Function

1 LCD1_DATA16 (R0) 2 LCD1_DATA17 (R1)

3 LCD1_DATA12 (R2) 4 LCD1_DATA13 (R3)

5 LCD1_DATA14 (R4) 6 LCD1_DATA15 (R5)

7 LCD1_DATA16 (R6) 8 LCD1_DATA17 (R7)

9 - 10 -

11 - 12 -

13 GND 14 GND

15 LCD1_DATA10 (G0) 16 LCD1_DATA11 (G1)

17 LCD1_DATA6 (G2) 18 LCD1_DATA7 (G3)

19 LCD1_DATA8 (G4) 20 LCD1_DATA9 (G5)

21 LCD1_DATA10 (G6) 22 LCD1_DATA11 (G7)

23 - 24 -

25 - 26 -

27 GND 28 GND

29 LCD1_DATA4 (B0) 30 LCD1_DATA5 (B1)

31 LCD1_DATA0 (B2) 32 LCD1_DATA1 (B3)

33 LCD1_DATA2 (B4) 34 LCD1_DATA3 (B5)

Digi ConnectCore Hardware Reference Manual

Other manuals for Digi ConnectCore