Digi ConnectCore

About the development board Ethernet 2 interface
ConnectCore for i.MX51 Hardware Reference Manual
83
Ethernet 2 interface
The development board provides a 2x20 expansion connector for connecting an optional Digi Ethernet
adapter board (100M_ETHADPT) or customer specific setup. The Ethernet 2 interface is provided by an
optional on-module Ethernet MAC/PHY.
Note The ConnectCore for i.MX51 modules included in the development kits are supporting the
Ethernet 2 interface.
Ethernet 2, connector J17
The table below shows the pinout of the Ethernet 2 expansion connector.
Pin Signal Pin Signal
1 GND 2 GND