Digi ConnectCore Hardware Reference Manual

About the module Module pinout
ConnectCore for i.MX51 Hardware Reference Manual
22
Pin I/O Type Signal name Use on module
Use on
development
board
Comments
J1:11
0
- - - - -
J1:11
1
GPIO33 ETH2_ACTIVITY# ETH_CTRL:
GPIO1/LED2#
Ethernet 2
Activity LED
J1:11
2
GPIO33 ETH2_LINK# ETH_CTRL:
GPIO0/LED1#
Ethernet 2
Link LED
J1:11
3
GPIO18 EIM_CS0/GPIO2_25 i.MX51: EIM_CS0 Peripheral
Application
Chip Select
J1:11
4
GPIO18 EIM_CS1/GPIO2_26 i.MX51: EIM_CS1 Not used
J1:11
5
GPIO18 EIM_CS2/GPIO2_27/FEC_
RDATA2/SISG5/CSI1_
D4/AUD5_TXD
i.MX51: EIM_CS2 Not used
J1:11
6
GPIO18 EIM_CS3/GPIO2_28/FEC_
RDATA3/SSI_EXT2_
CLK/CSI1_D5/AUD5_RXD
i.MX51: EIM_CS3 Not used
J1:11
7
GPIO18 EIM_CS4/GPIO2_29/FEC_
RX_ER/SSI_EXT1_
CLK/CSI1_D6/AUD5_TXC
i.MX51: EIM_CS4 Not used
J1:11
8
GPIO18 EIM_CS5/GPIO2_30/FEC_
CRS/DI1_EXT_CLK/CSI1_
D7/AUD5_TXFS
i.MX51: EIM_CS4
EHT_CTRL: CS#
Reserved
J1:11
9
GPIO18 EIM_DTACK/GPIO2_31 i.MX51: EIM_DTACK Not used
J1:12
0
GPIO18 EIM_LBA/GPIO3_1 i.MX51: EIM_LBA Not used
J1:12
1
GPIO18 EIM_DA0/TRACE16 i.MX51: EIM_DA0
ETH_CTRL: A1
Peripheral
Application
Data / Address
J1:12
2
GPIO18 EIM_DA1/TRACE17 i.MX51: EIM_DA1
ETH_CTRL: A2
Peripheral
Application
Data / Address
J1:12
3
GPIO18 EIM_DA2/TRACE18 i.MX51: EIM_DA2
ETH_CTRL: A3
Peripheral
Application
Data / Address

Digi ConnectCore Specifications

General

Brand	Digi
Model	ConnectCore
Category	Control Unit
Language	English