Digi SM-5300 - MAC Address and VNC Password Setup

M o d e l S M - 5 3 0 0 U s e r M a n u a l | 56
Typical Operation
–––––––––––––––––––––––––––––––––––––––
2.4 Self Service Mode
OPERATION
DISPLAY
4.
After issue out label will direct prompt out
message "PEEL LABEL".
Note: Please take out the label before continue
to do next transaction.
5.
Press [MENU] button will back to Original
MENU mode.
Note: We can used auto run self service mode when scale start up by set the SPEC 141D040 AUTO
ENTRY TO OPERATION MODE set to SELF SERVICE, set to YES
All manuals and user guides at all-guides.com