Digisol DG-BG4100NU - Page 38

DG-BG4100NU User Manual
38
The following table describes the parameters of this page:
Field
Description
WAN physical ty pe: Ethernet
WAN (Port-LAN1)
When this option is selected the unit will auto reboot.
Def ault Route Selection
You can select Auto or Specif ied.
VPI
The virtual path between two points in an ATM network,
ranging f rom 0 to 255.
VCI
The v irtual channel between two points in an ATM network,
ranging from 32 to 65535 (1 to 31 are reserv ed for known
protocols)
Encapsulation
You can choose LLC and VC-Mux.
Channel Mode
You can choose PPPoE, PPPoA and 1483 Routed.
Enable NAPT
Select it to enable Network Address Port Translation (NAPT)
function. If y ou do not select it and you want to access the
Internet normally, y ou must add a route on the uplink
equipment. Otherwise, the access to the Internet fails.
Normally, it is enabled.
Enable IGMP
You can enable or disable Internet Group Management
Protocol (IGMP) function.
PPP Settings
User Name
Enter the correct user name f or PPP dial-up, which is provided
by your ISP.
Password
Enter the correct password for PPP dial-up, which is prov ided
by your ISP.
Type
You can choose Continuous, Connect on Demand, or Manual.
Idle Time (min)
If set the type to Connect on Demand, you need to enter the
idle timeout time. Within the preset minutes, if the router does
not detect the f low of the user continuously, the router
automatically disconnects the PPPoE connection.
WAN IP Settings
Type
You can choose Fixed IP or DHCP.