C
HAPTER
5
| Port Settings
– 46 –
N
OTE
:
Avoid using flow control on a port connected to a hub unless it is
actually required to solve a problem. Otherwise back pressure jamming
signals may degrade overall performance for the segment attached to the
hub.
Current Port Status
◆ Port – The number of the port or trunk interface.
◆ State – Indicates if the port is enabled or disabled.
◆ Speed/Duplex – Displays the following:
■
Config – The configured speed/duplex mode of the port.
■
Actual – Indicates the link status of the port. When a link is up,
indicates the operating speed and duplex mode.
◆ Flow Control – Displays the following:
■
Config – The configured flow control mode of the port.
■
Actual – Indicates the link status of the port. When a link is up,
indicates the operating flow control mode.
WEB INTERFACE
To configure port connection settings in the web interface:
1. Click System, Port Setting.
2. Select one or more ports or trunks to configure.
3. Make any required changes to the connection settings.
4. Click Apply.
To Next Page
Loading...
Need help?
General
