42 Scale Link 2 Technical Manual D4204-EN
MENU 2.7 – ISOBUS (JUMP LIST 27)
ISO WT (D.A.N. 2701) Isobus Weight
Set to periodically output the most current Gross, Net & Load/Unload weights to external devices connected to the
Serial Port. Settings start at "OFF" (no transmissions) and increase in 0.1 second increments up to 2.0 seconds.
ISOADR (D.A.N. 2702) Isobus Base Address
Allow the ISOBUS Scale Link to claim a specific address. Upon being commanded to change addresses, the
ISOBUS Scale Link stores the new address, ends the use of the current address, and performs a new address claim
starting at the new address. The default address is typically 144 (0x90).
ISOINT (D.A.N. 2704) ISOBUS VT INSTANCE NUMBER
Preferred virtual terminal instance to display mask on.
ISOINT (D.A.N. 2705) Isobus VT Instance Number
Preferred virtual terminal instance to display mask on.
ISO SG (D.A.N. 2706) Isobus Serial Gross
Enables serial gross output to be transmit on CANBUS.
CANMSG (D.A.N 2711) CAN MESSAGE TYPE
Allows for entry of a proprietary can message type.
CANINT (D.A.N 2712) CAN MESSAGE INTERVAL
Allows editing of the interval time for the CANMSG output.
MENU 2.8 – WIFI (JUMP LIST 28)
WIFINM (D.A.N. 2801) WIFI NAME
WIFI network SSID
WIFIPS (D.A.N. 2802) WIFI Password
Password for WIFI network
WIFICH (D.A.N. 2803) WIFI Channel
Select WIFI channel number for Datalink and/or Cab Control communications.
WIFVER (D.A.N. 2804) Display WIFI Version
Displays version of connected WIFI-ERM.
To Next Page
Loading...