DIGITAL-LOGIC Microspace MSM586SEN - Page 83

DIGITAL-LOGIC AG MSM586SEN/SEV Manual V1.5E
83
J7M VGA Monitor (CRT-Signals)
J7 L/M Header 15 pins HiDensity D-SUB
40 Pin -L 10 Pin -M
Signal Pin Signal
Pin 32 Pin 2 VGA red Pin 1 Red
Pin 34 Pin 4 VGA green Pin 2 Green
Pin 36 Pin 6 VGA blue Pin 3 Blue
Pin 38 Pin 8 Horizontal synch Pin 13 H- synch
Pin 39 Pin 9 Vertical synch Pin 14 V- synch
Pin 5 + 11 Bridge
Pin 31 Pin 1 Ground Pin 5, 6, 7, 8 Ground
Pin 33 Pin 3 LCD-P20
Pin 35 Pin 5 LCD-P21
Pin 37 Pin 7 LCD-P22
Pin 40 Pin 10 LCD-P23
The VGA-CRT signals from J7 must be wired to a standard VGA HiDensity DSub connector (female):
The LCD signals must be wired panel specific.
Solderside view of the female 15pin HiDSub
1 2 3 4 5
Red Green Blue GND
6 7 8 9 10
GND
11 12 13 14 15
Hsyn VSyn
J55 DDC connector (not assembled)
Pin Signal Pin 69000
Pin 1 = VSDA Pin V3
Pin 2 = VSCL Pin U4
J43 10/100 BASE-T Interface connector
J43 Pin * Signal RJ-45 Pin Signal
Pin 1 = TX+ Pin 1 = TX+
Pin 2 = TX- Pin 2 = TX-
Pin 3 = RX+ Pin 3 = RX+
Pin 4 = RX- Pin 6 = RX-
* This signals are ready to connect directly to a RJ-45 connector.
1 2 3 4 5 6 7 8
RJ
-
45