Digital Systems DSF22 - SMS Commands; Syntax of SMS Commands; Read Commands; Write Commands

DSF22 UNIQUE MONITORING TERMINAL
15
INSTALLATION AND SETUP GUIDE
SMS commands.
Each terminal parameter can be accessed (read and modified) by SMS commands. There are two types
of SMS commands – reading and writing commands. Reading commands returns current parameter
value from device memory, writing commands overwrites previous parameter value with new and
returns a new parameter value.
Syntax of SMS commands.
All SMS commands must be written with capital letters, in case if wrong SMS command has been sent,
device will ignore it.
Read commands
Read commands always starts with GET, followed by space and then parameter number at the end.
Example of reading parameter P11 (server IP address):
GET P11
Response from device:
P11: 80.81.57.66
Write commands
Write commands always starts with SET, followed by space, then parameter number, space again and
then new parameter value at the end.
Example of setting parameter P11 (server IP address):
SET P11 195.126.118.111
Response from device:
P11: 195.126.118.111