Digital Systems DSF22 - P22 GPS Time Threshold; P23 PING Time

DSF22 UNIQUE MONITORING TERMINAL
22
INSTALLATION AND SETUP GUIDE
P22 GPS time threshold
Description
Defines GPS time (seconds) to trigger new event. This parameter used only
when ignition is switched ON and no other event has been triggered during
defined time.
Options
Parameter can be read and modified.
Used values
0 – GPS time trigger disabled.
1-250 – GPS time trigger enabled, value equals to vehicle seconds
Maximal value allowed - 250
Default value
180
Comments
Example
To read parameter:
GET P22
To set parameter:
SET P22 100
Response from device:
P22: 100
P23 PING time
Description
Defines PING interval (minutes) in home networks (also called as
heartbeat). This parameter used only when ignition is switched OFF. In
case if ignition switched OFF and defined time is reached, terminal will
trigger event.
Options
Parameter can be read and modified.
Used values
0 – PING disabled
1 – 250 - PING enabled, value equals to minutes between each PING
Maximal value allowed - 250
Default value
60
Comments
Example
To read parameter:
GET P23
To set parameter:
SET P23 30
Response from device:
P23: 30