Digital Systems DSF22 - P24 New Event Wait Time; P25 PING Interval in Roaming Networks

DSF22 UNIQUE MONITORING TERMINAL
23
INSTALLATION AND SETUP GUIDE
P24 New event wait time
Description
Defines time (seconds) for collecting data for next data block to be sent.
During this time terminal keeps all unsent events and waits for new event
to include it the data block. In case if defined time is reached (no new
events has been triggered), terminal sends all unsent events to server.
If parameter set to 0, terminal will send event right after event has been
triggered.
Options
Parameter can be read and modified.
Used values
0 – Event wait time disabled.
1-250 – Event wait time enabled, value equals to seconds for new event
waiting.
Maximal value allowed - 250
Default value
5
Comments
Example
To read parameter:
GET P24
To set parameter:
SET P24 10
Response from device:
P24: 10
P25 PING interval in roaming networks
Description
Defines PING interval (minutes) in roaming networks (also called as
heartbeat). This parameter used only when ignition is switched OFF. In
case if ignition switched OFF and defined time is reached, terminal will
trigger event.
Options
Parameter can be read and modified.
Used values
0 – PING disabled
1 – 250 - PING enabled, value equals to minutes between each PING
Maximal value allowed - 250
Default value
60
Comments
Example
To read parameter:
GET P25
To set parameter:
SET P25 120
Response from device:
P25: 120