Digital Systems DSF22 - P20 GPS Angle Threshold; P21 GPS Start Speed Threshold

DSF22 UNIQUE MONITORING TERMINAL
21
INSTALLATION AND SETUP GUIDE
P20 GPS angle threshold
Description
Defines GPS angle changes to trigger new event in tracking mode (when
ignition is switched on). In case ignition is switched off, this parameter is
not used.
Options
Parameter can be read and modified.
Used values
0 – GPS angle change trigger disabled.
1-250 – GPS angle change trigger enabled, value equals to decimal degrees
of driving angle change to trigger new event.
Maximal value allowed - 250
Default value
4
Comments
Example
To read parameter:
GET P20
To set parameter:
SET P20 5
Response from device:
P20: 5
P21 GPS start speed threshold
Description
Defines GPS start speed (km/h). In case if vehicle speed is less than GPS
start speed threshold parameter, terminal will not trigger GPS angle
events. This parameter is used only in tracking mode and not used when
ignition switched off.
Options
Parameter can be read and modified.
Used values
0 – GPS start speed disabled.
1-250 – GPS start speed enabled, value equals to vehicle speed (km/h) to
start monitor driving angle
Maximal value allowed - 250
Default value
2
Comments
Example
To read parameter:
GET P21
To set parameter:
SET P21 5
Response from device:
P21: 5