Digital Systems DSF22 - P26 Static STOP Coordinates; P27 Anti-Sabotage Function

DSF22 UNIQUE MONITORING TERMINAL
24
INSTALLATION AND SETUP GUIDE
P26 Static STOP coordinates
Description
This parameter enables/disables static GPS coordinates for parking time. If
static coordinates are enabled, terminal will send same coordinates with
each PING (during parking time). If static coordinates are disabled,
terminal will send new (actual) coordinates with each PING
Options
Parameter can be read and modified.
Used values
0 – Static coordinates disabled
1 – Static coordinates enabled
Default value
1
Comments
Example
To read parameter:
GET P26
To set parameter:
SET P26 0
Response from device:
P26: 0
P27 Anti-sabotage function
Description
This function allows detecting situations, when vehicle driver are trying to
interrupt GPS signal, by disconnecting GPS antenna or by jamming GPS
signal. In case if this function is enabled and terminal lost a GPS signal
during driving, terminal becomes in Anti-sabotage mode. In this mode
terminal sends last valid position (before loss of GPS signal) and all actual
data (time, fuel data, inputs and outputs). Also special flag bit is set, that
allows detecting this mode in server.
In case if this function is disabled and terminal lost GPS signal, no new
events will be triggered until GPS signal will be restored.
Options
Parameter can be read and modified.
Used values
0 – Anti-sabotage disabled
1 – Anti-sabotage enabled
Default value
1
Comments
Example
To read parameter:
GET P27
To set parameter:
SET P27 0
Response from device:
P27: 0